Category: Photography

Home 3D Repository Photography
Hasselblad A12/24 Darkslide Keeper-JCHP

Not wanting to risk bending my Hassy dark slides by dropping them in a pocket, or lose it by setting it down somewhere when shooting, I designed a keeper that hangs ’round my neck and supports the entire surface area of of the Hasselblad V series A12 / A24 dark slide while it’s out of […]

Hasselblad Darkslide Holder

Based on the Lindahl holder. The cutout lets you see the film reminder window while also saving weight and material. *After it’s printed you may need to use a razor blade to make sure the opening is completely free for the darkslide to slide into URL: http://www.thingiverse.com/thing:2463497 Author: bogucki@thingiverse

Hasselblad 500 EL/M Battery Door Lock Screw

A replacement for the plastic screw-like part of a Hasselblad 500 EL/Ms battery door. URL: http://www.thingiverse.com/thing:75518 Author: fluetke@thingiverse

Hasselblad cable mount for H Series

I was annoyed as my flash cable falls of the sync port all the time. On the other hand I was scared while shooting tethered I will fall over the cable and pull the cable out of the back. So I decided to use the “heavily” used accessory port. Originally this nice addon port is […]

Hasselblad 500 series camera strap lug

You will need a 62mm to 67mm filter adapter ring to make use of this hood as there is a retention ring to hold the hood into place (i didn’t need to use any glue as it was tight enough to keep it in place). Print these two part separately and the small ring should […]